Konica Minolta IC-304 Plus Service Manual page 111

3. Remove the side cover (see Removing the Side Cover on page 93).
Tip:
It is easier to perform this procedure if you place the server on its side
on a table, with the front panel of the tower computer case protruding over
the table edge.
4. Inside the chassis, lift the two protruding tabs that secure the front panel to the
front of the chassis and move the edge of the front panel slightly away from the
chassis. See step 4 in Figure 3 and Figure 4 on page 96.
5. Using a flat screwdriver, gently pry the four concealed tabs along the edge of
the front panel away from the chassis.
4
4 Inside the chassis, lift the two protruding tabs.
5 Pry the edge of the front panel away from the chassis and open
outward.
Figure 3: Removing the front panel
5
95