Konica Minolta IC-304 Plus Service Manual page 115

6. Continue to lift the board and remove it from the computer.
Figure 7: FusionIN board and memory modules
Removing Memory Modules
1. Place the board, component-side up, on a flat, antistatic surface.
2. Remove the memory modules from the board positions: IN_MEM, OUT_MEM.
a. Remove a memory module from the FusionIN board by locating and
opening the two locking clips (one on each side of the memory module).
To open the locking clips, push the clips outward from the side of the
module. See Figure 7.
b. Slide the memory module out of its housing.
c. Store the board in a safe place for future use.
Installing Memory Modules
1. Install the memory modules in the same housing position on the new board as
they were installed on the old board.
Important:
The FusionIN memory configuration must be as follows:
Input memory = 1 X DDR: IN_MEM
Output Memory = 2 X DDR: OUT_MEM
2. Insert the memory module and push it gently into the housing until it is seated.
IN_MEM
OUT_MEM
99
OUT_MEM