Operation & Service Manual
Installation Battery & ignition key harness fitting
Carrier Transicold Europe
1. Route the ignition cable to the vehicle fuse box.
2. Connect the white wire onto the fuse holder supplied in the
mounting kit (1A).
3. Refer to the corresponding mounting kit instruction to
connect the +12Vdc ignition live.
4. Cut the battery harness to the required length.
5. Strip the + battery (35mm
+ microprocessor positive.
6. Using a crimping tool, install the (125A) fuse supplied with
the mounting kit.
NOTE : Soft-solder is recommended.
31/03/07
2
red) and the fuse holder for the
Viento - Installation/Rev- #44/54