Driver Cab Preparation - Carrier Viento 200 Operation & Service Manual

Operation & Service Manual
Installation Driver cab preparation
Carrier Transicold Europe
RECOMMENDATIONS
Before drilling the floor, check the location of
fuel tank, harness and/or tubes.
1. Drill a hole in the cab floor (behind driver or passenger
seat – depends on battery location).
RECOMMENDATIONS
Protect the hole (ex: armoured hose) to avoid
harness damage.
2. Run water drain hose through the floor.
3. Run battery cable through the floor.
4. Run the cab command and ignition cable to the
dashboard.
5. Install a capping (not supplied) to cover the hoses and
harness.
6. Insulate the water drain hose.
31/03/07 Viento - Installation/Rev- #37/54