Compaq ProLiant Clusters HA/F100 Administrator's Manual page 95

Setting Up the Compaq ProLiant Clusters HA/F100 and HA/F200 3-15
Cluster-Specific SmartStart Installation
The SmartStart Setup Poster describes the typical procedure for configuring
and installing software on a single server. The installation for Compaq
ProLiant Clusters HA/F100 and HA/F200 will be similar. The difference
between running SmartStart on a stand-alone server and running SmartStart
for a cluster are noted below:
I
Through the Compaq Array Configuration Utility, you can configure the
shared drives on both servers. For cluster configuration, configure the
drives on the first server, then accept the same settings for the shared
drives when given the option on the second server.
I
When configuring drives through the Array Configuration Utility, create
a logical drive with 100MB of space to be used as the quorum disk.
Assisted Integration Installation Steps
IMPORTANT: Power down Node 2 when setting up Node 1.
1. Power up your hardware in the following manner:
a. Fibre Channel storage hub or FC-AL switch (power is applied when
the AC cord is plugged in).
b. Shared storage and wait for drives to spin up.
c. Node 1 and place the SmartStart CD in the CD-ROM drive. The CD
will automatically run.
2. Select the Assisted Integration installation path. Follow steps outlined in
the SmartStart Setup Poster.
3. Select one of the following when SmartStart prompts for the operating
system:
Microsoft Windows NT Server 4.0/Enterprise Edition (Retail)
Microsoft Windows NT Server 4.0/Enterprise Edition (Select)
Microsoft Windows 2000 Advanced Server