Compaq ProLiant Clusters HA/F100 Administrator's Manual page 126

c. Insert the Options ROMPaq diskette into Node 1 and restart the
node. Run Options ROMPaq and choose to update the firmware on
the RA4000 Controllers.
d. Power down the storage and Node 1 after the firmware update
completes.
7. Power on the storage (wait for the drives to spin) and power on both
nodes.
8. Verify the cluster by running the Compaq Cluster Verification Utility.
Instructions for installing and running this utility can be found in
Chapter 3 of this guide.
9. Verify that Compaq Redundancy Manager is running properly and that
the cluster's redundant paths are operational. Instructions for running
Compaq Redundancy Manager are included in Chapter 5 of this guide.
10. Install your applications, managing and monitoring software as needed.
These may include, Compaq Insight Manager, Compaq Insight Manager
XE, Compaq Intelligent Cluster Administrator and other applications
needed on this cluster.
Upgrading the ProLiant Clusters HA/F100 and HA/F200 4-21