Compaq ProLiant Clusters HA/F100 Administrator's Manual page 29

1-16 Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide
Compaq System Configuration Utility
The SmartStart and Support Software CD also contains the Compaq System
Configuration Utility. This utility is the primary means to configure hardware
devices in your server, such as I/O addresses, boot order of disk controllers,
and so on.
For information concerning the Compaq System Configuration Utility, refer to
the Compaq Server Setup and Management pack.
Compaq Server Support (SSD) for Microsoft
Windows NT 4.0
The Compaq Server Support (SSD) for Microsoft Windows NT 4.0 contains
device drivers and utilities that enable you to take advantage of specific
capabilities offered on Compaq products. These drivers are provided for use
with Compaq hardware only.
The SSD is included in the Compaq Server Setup and Management pack.
Compaq Support Paq for
Microsoft Windows 2000
The Compaq Support Paq for Microsoft Windows 2000 is an advanced
software delivery tool that replaces the familiar SSD utility vehicles used for
support of Windows NT 3.51 and Windows NT 4.0. The Compaq Support Paq
for Microsoft Windows 2000 includes an installer that analyzes system
requirements and installs all drivers.
The Compaq Support Paq can be installed or downloaded from the Compaq
website ( ).
www.compaq.com/support
Options ROMPaq Utility
The SmartStart and Support Software CD also contains the Options
ROMPaq™ utility. Options ROMPaq updates the firmware on the Compaq
StorageWorks RA4000 Controllers and the hard drives.
Fibre Channel Fault Isolation Utility (FFIU)
The SmartStart and Support Software CD also contains the Fibre Channel
Fault Isolation Utility (FFIU). The FFIU verifies the integrity of a new or
existing FC-AL installation. This utility provides fault detection and help in
locating a failing device on the FC-AL.