Compaq ProLiant Clusters HA/F100 Administrator's Manual page 133

Managing the Compaq ProLiant Clusters HA/F100 and HA/F200 5-7
4. Connect the additional RA4000/4100 to the Fibre Channel storage hub
or FC-AL switch. Follow the hardware installation steps detailed in
Chapter 3 of this guide.
5. Power on the newly added RA4000/4100.
6. Power on Node 1 and run the Array Configuration Utility (ACU).
Create a new drive. Refer to the Compaq StorageWorks RAID Array
4000 or 4100 User Guide for more information about Compaq Array
Configuration Utility.
IMPORTANT: Be sure to understand your cluster groupings for applications and
resources whose data, log, and, possibly, program files will reside on these drives. See
Chapter 2 for information about creating cluster groups.
7. Save the configuration changes and exit ACU. Remove the
SmartStart CD.
8. Boot Node 1 to Windows NTS/E or Windows 2000 Advanced Server,
then run Disk Administrator for Windows NTS/E or Disk Management
for Windows 2000 Advanced Server to assign permanent letters to the
drive volumes and configure the newly added disks for use in a cluster.
Refer to Microsoft documentation for more details.
9. Open Cluster Administrator. The newly created disk is now ready to
participate in the cluster. Follow the MSCS documentation for details
about adding new cluster resources.
IMPORTANT: Do not run the Array Configuration Utility on the second cluster node. The
information entered from the first cluster node is maintained on the drives; therefore, the
drives are already configured for the second node.
10. Power on Node 2 and log onto Windows NTS/E or Windows 2000
Advanced Server. Refer to the MSCS documentation for procedures to
verify that the newly created cluster resources are operational on
Node 2.