Compaq ProLiant Clusters HA/F100 Administrator's Manual page 99

Setting Up the Compaq ProLiant Clusters HA/F100 and HA/F200 3-19
18. If configuring an HA/F200 with Windows 2000 Advanced Server,
install Secure Path on both nodes using the following steps:
a. Insert the Secure Path CD to automatically start the Secure Path
installation process. Alternatively, double click the following file on
the CD:
<CD- ROM drive>:\SPInstall\setup.exe
b. During the installation, you are required to configure your clients.
Remove the Compaq SANworks Secure Path CD from the CD-ROM
drive.
c. Reboot the node when prompted.
To use Secure Path select Start, Programs, SecurePath, SPM.
NOTE: If you have problems authorizing client connections using Fully Qualified Domain
Names (FQDN), it may be due to a Domain Name Service (DNS) resolution issue, and can
be resolved by a HOSTs file entry containing relevant FQDN to IP address mapping.
For more detailed information on Secure Path, refer to the Secure Path
documentation.
19. Run the Compaq Cluster Verification Utility CD from your cluster kit to
ensure that your node is ready for cluster installation.
Refer to the CCVU online help for detailed information on running
CCVU.
NOTE: You must have administrative accounts with identical username and password on
the computers selected.
IMPORTANT: When setting up the cluster, both nodes must have the operating system
installed prior to installing and configuring MSCS.
20. Install MSCS for Node 1.
For Windows NTS/E, open the Enterprise Edition Installer and
install MSCS on both cluster nodes as outlined in MSCS
documentation.
For Windows 2000 Advanced Server, install the Cluster Service
(MSCS) component in Add/Remove Programs. For more
information on installing and configuring MSCS, refer to your
Windows 2000 Advanced Server documentation.
21. Install MSCS for Node 2.
22. Run CCVU again to verify successful cluster installation.