Compaq ProLiant Clusters HA/F100 Administrator's Manual page 119

4-14 Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide
c. Verify the configuration changes to the system (a host bus adapter
was added).
d. Save configuration changes and reboot.
e. Add the Fibre Channel host bus adapter driver when the Windows
2000 Found New Hardware Wizard appears.
6. If the firmware version numbers are the same and at least version 2.58
then skip to step 8. Otherwise complete step 7 to upgrade the RA4000
Controller firmware.
7. Upgrade the RA4000 Controller firmware:
a. Create the Options ROMPaq diskettes from the Diskette Builder
Utility by inserting the SmartStart CD and selecting Start and then
Run. In the dialog box that displays, type
is the drive letter associated with your CD-ROM drive.
You can also acquire and run the latest Options ROMPaq from the
Compaq website (
b. Power down Node 1 and Node 2.
c. Insert the Options ROMPaq diskette into Node 1 and restart the
node. Run Options ROMPaq and choose to update the firmware on
the RA4000 Controllers.
d. Power down the storage and Node 1 after the firmware update
completes.
e. Power on the storage, wait for the drives to spin, and power on
Node 1.
8. Install Secure Path on Node 1, and reboot when prompted. See the
Secure Path detailed installation instructions in Chapter 3 for more
detail if needed.
9. Move all cluster resources from Node 2 to Node 1. Skip this step if the
firmware update procedure was performed (Step 7).
http://www.compaq.com/support
where X
X:\dskbldr\setup.exe
).