Compaq ProLiant Clusters HA/F100 Administrator's Manual page 123

4-18 Compaq ProLiant Clusters HA/F100 and HA/F200 Administrator Guide
IMPORTANT: If using the Compaq StorageWorks FC-AL Switch 8 be sure to properly set
up the Port LIP Propagation Policies correctly. See Chapter three for more details.
b. Turn on Node 1 and run the System Configuration Utility by
pressing F10 when prompted during boot time.
c. Verify the configuration changes to the system (a host bus adapter
was added).
d. Save configuration changes and reboot.
e. Add the fibre host bus adapter driver when the Windows 2000
Found New Hardware Wizard appears.
9. If the firmware version numbers are the same and at least version 2.58
then skip to Step 11. Otherwise complete step 10 to upgrade the
RA4000 Controller firmware.
10. Upgrade the RA4000 Controller Firmware:
a. Create the Options ROMPaq diskettes from the Diskette Builder
Utility by inserting the SmartStart CD and selecting Start and then
Run. In the dialog box that displays, type
is the drive letter associated with your CD-ROM drive.
NOTE: You can also acquire and run the latest Options ROMPaq from the Compaq
website (http://www.compaq.com/support).
b. Power down Node 1 and Node 2.
c. Insert the Options ROMPaq diskette into Node 1 and restart the
node. Run Options ROMPaq and choose to update the firmware on
the RA4000 Controllers.
d. Power down the storage and Node 1 after the firmware update
completes.
e. Power on the storage (wait for the drives to spin) and power on Node
1.
11. Install Secure Path on Node 1, and reboot when prompted. See the
Secure Path detailed installation instructions in Chapter 3 for more
detail if needed.
12. Move all cluster resources from Node 2 to Node 1. Skip this step if the
firmware update procedure was performed (Step 10).
13. Upgrade Node 2 by repeating steps 2 through 6, 8, and 11 for Node 2
and then continuing with Step 14.
where X
X:\dskbldr\setup.exe