009 [Rx] Recording Paper Has Jammed Or The Recording Paper Has Run Out - Canon LaserBase MF5600 Service Manual

Chapter 5
Cause
The other party's communication mode (G2, G3, etc.) does not match.
Remedy
The communication mode depends on each specific model, and no remedy can be offered.
Cause
During transmission, the other party malfunctioned because of an echo.
Remedy
1) Using a manual call, press the Start button after hearing the 1st DIS from the other party.
2) To prevent response to the 1st DIS from the other party, put a relatively long pause to the telephone number when
registering an auto-dial number.
3) Ask the operator of the other party to provide echo remedy 2.
4) Ask the operator of the other party to decrease the transmission level.
Cause
During reception, the machine malfunctioned because of an echo.
Remedy
Provide echo remedy 2.
Memo
Echo Remedy 2 (by the receiving machine; adds a 1080-Hz total signal before transmission of CED)
Set SW03 bit 7 of service soft switch #1 SSSW to '1' so that a 1080-Hz total signal is transmitted before
transmission of CED.

5.5.2.5 #009 [RX] Recording paper has jammed or the recording paper has run out

Cause
The recording paper is trapped.
Remedy
Remove the trapped recording paper.
Cause
The recording paper has run out.
Remedy
Set new recording paper.
5-10
0007-2941