Removing The Scanner Unit; Removing The Plate - Canon LaserBase MF5600 Service Manual

Chapter 3
3.5.2.9 Removing the NCU
Case
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
[2]
F-3-325
3.5.2.10 Removing the Scanner
Unit
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
[2] [1]
F-3-326
2) Remove the two front screws [1].
3-76
0006-3669
[1]
0006-3670
[3]
[1]
F-3-327
3) Remove the two screws on the back [1]. Slide the
scanner unit [2] to the back; then, remove it by
lifting it.
[1]
F-3-328

3.5.2.11 Removing the Plate

1) Remove the connector [1] of the DCNT board.
2) Remove the three screws [2] and then removes the
plate [3].
[3]
[2]
F-3-329
[2]
0006-3671
[1]