001 [Tx] Document Has Jammed; 003 [Tx/Rx] Document Is Too Long, Or Page Time-Over - Canon LaserBase MF5600 Service Manual

Chapter 5

5.5.2.2 #001 [TX] Document has jammed

Cause
The document is trapped in the feeder.
Remedy
Remove the document, and try again.
Cause
The document is not of a standard size or thickness.
Remedy
Using a copying machine, make an A4/LTR copy of the document to transmit.
Cause
An internal mechanism is faulty.
Remedy
1) Check if the document sensor (DS) and document edge sensor (DES) are operating correctly using the Sensor tests
under the Faculty Tests in the Test mode.
2) Check the actuator of the document sensor (DS) and the one of the document edge sensor (DES) are properly
attached.
3) Check the document sensor (DS), document edge sensor (DES) and SCNT board (J806) connections.
4) Make a copy,and make sure that the document read motor is operating corrctly.
5) Check the document read motor and SCNT board (J805) connections.
6) Replace the document sensor (DS).
7) Replace the document edge sensor (DES).
8) Replace the document read motor.
9) Replace the SCNT board.

5.5.2.3 #003 [TX/RX] Document is too long, or page time-over

Cause
The length of a single page is too long.
Remedy
1) Using a copying machine, make copies of the document, and transmit the copies separately.
2) For making copies, use a copy machine.
Cause
The data of a single page is too large, exceeding the time allowed for transmission.
Remedy
1) Decrease the reading resolution when transmitting.
2) If the document is too long and the data is too large, make copies using a copying machine, and transmit the copies
separately.
5-8
0007-2927
0007-2930