Removing The Ncu Board; Removing The Ncu Case; Removing The Scanner Unit - Canon LaserBase MF5600 Service Manual

3.6.2.8 Removing the NCU
Board
1) Remove the two connectors [1] and the flat cable
[2].
2) Remove the two screws [3] and remove the NCU
board [4].
[3]
[4]
[2]
F-3-445
3.6.2.9 Removing the NCU
Case
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
[2]
F-3-446
0006-3739
[1]
0006-3732
[1]
3.6.2.10 Removing the Scanner
Unit
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
[2] [1]
F-3-447
2) Remove the two front screws [1].
[1]
F-3-448
Chapter 3
0006-3734
[3]
3-103