3.2.5.6 Removing the NCU
Board
1) Remove the two connectors [1] and the flat cable
[2].
2) Remove the two screws [3] and remove the NCU
board [4].
[3]
[4]
[2]
F-3-272
3.2.5.7 Removing the NCU
Case
1) Remove the three screws [1]; then, pull the upper
portion of the NCU case [2] toward you, and lifting
it upward, remove the NUC case.
[2]
F-3-273
0006-3660
[1]
0006-3659
[1]
3.2.5.8 Removing the Scanner
Unit
1) Remove the screw [1] and remove the connector [2]
as well as the flat cable [3] on the DCNT board.
Remove the tape holding the cable in advance.
Prepare a new tape (Part No: AZ7-0008) of a suitable
length before you attach the cable again.
[2]
[1]
F-3-274
2) Remove the two front screws [1].
[1]
F-3-275
Chapter 3
0006-3658
[3]
3-63