Parts Replacement Procedure; Laser/Scanner Unit; Removing The Laser Scanner Unit - Canon LASER CLASS 810 Service Manual

6.2 Parts Replacement Procedure

6.2.1 Laser/Scanner Unit

6.2.1.1 Removing the Laser Scanner Unit

The laser scanner was-factory adjusted. Never disassemble it.
1) Remove the rear cover and front cover.
2) Remove the right cover and tray lower cover.
3) Remove the control panel and delivery tray.
4) Remove the laser shutter [1].
5) Remove the laser scanner unit [2].
- Connector [3] 1pc.
- Flexible cable [4] 1pc.
- Screw [5] 4pcs. (using the stubby screwdriver)
[2]
[1]
MEMO:
When reinstalling the laser scanner unit, it is difficult to install the encircled
screw if your stubby screw driver is not magnetized. In this case, first install
the screw in the screw hole on the laser scanner unit, place the laser scanner
unit in place, and then tighten the screw tightly.
[4]
[5] [3]
[5]
F-6-2
F-6-3
0017-3122
Chapter 6
6-3