Kodak Series 3 User Manual page 7

6
Print Position
The print position specifies how far from the leading edge (fed into the
transport first) of the document the information will be printed. The
default print position is defined at installation.
You can temporarily change the default print position by using function
code F46. The new print position will be used to print information until
function code F02 (Restore Mode) is used to return the starting print
position to its original value (provided mode overrides are not saved), or
until function code F46 is used again to change the print position(s).
NOTES:
Restore Mode (F02) restores all initial printer settings, except the
print contrast setting and print alignment.
The print position should be carefully calculated. Make sure to set
the print position close enough to the leading edge of the document
so the printed information is not truncated before reaching the
trailing edge of the document.
Leading edge
(fed into transport first
03.040.001
FRI 11-16-97
15:00
TEST
)
Starting print position
Trailing edge
A-61121 May 1999