Kodak Series 3 User Manual page 19

Kodak user's guide super12 document printer

Hide thumbs Also See for Series 3:

7. Enter function code F40 and press Enter. The following message

will be displayed:

Print Head Position

1=Change Head(s) 2=Clean Printer

8. Select 2; a Please Wait message will be displayed. When this

message is no longer displayed, open the front cover of the

scanner.

9. Lift the printer out of the printer bracket and place it on the feeder

top cover.

10. With a supplied swab, wipe off the rubber gaskets and the area

around the gaskets.

NOTE: The rubber gaskets can be removed and cleaned.

Periodically, it may be necessary to replace the rubber

gaskets with a new set. Make sure the gaskets are seated

properly before continuing.

11. Wipe off any ink build-up on the rubber wipers.

12. Tilt the Super12 Document Printer, as illustrated, and wipe the flex

cable connectors and splatter guards.

Splatter guards

Flex cable connectors

13. When finished, place the Super12 Document Printer into the

desired print location.

14. Close the front cover.

Gaskets

Wipers

A-61121 May 1999

Table of Contents

Super12