Kodak Series 3 User Manual page 21

Cleaning the transport
area
20
To thoroughly clean the transport area, perform the following procedure:
1. Open the front cover.
2. Note the current location of the Super12 Document Printer, then lift
it from the printer bracket, being careful not to strain the flex cable.
3. Place the Super12 Document Printer on the hanger bracket to keep
it out of the way while you are cleaning other areas of the machine.
CAUTION: Hot surface, avoid contact.
NOTE: Be sure the flex cable is placed between the two hooks so it
does not get damaged.
Hanger bracket
The following illustrations show the transport areas which need to be
cleaned and how to clean them:
1. Lift the transport plate.
2. Wipe the transport plate surfaces with a slightly water-dampened,
lint-free cloth to remove any ink deposits. Ensure that the topside of
the print locations are clean.
3. Wipe the bottom of the transport plate thoroughly with a slightly
water-dampened, lint-free cloth. Make certain that the underside of
the print locations are clean.
4. Insert the Super12 Document Printer into the desired position in the
transport plate, being careful not to strain the flex cable.
5. Close the front cover.
A-61121 May 1999