Kodak Series 3 User Manual page 29

28
If E206 continues to be displayed or the flex cable lights continue to
flash, enter F45 to do a Print Test. If the print quality is acceptable,
ignore the E206 error or the flashing flex cable lights.
If the print quality is not acceptable, try changing one or both of the print
cartridges, then enter F45 again to do another Print Test.
If the print quality is still not acceptable, the flex cable may not be
working properly. Call service.
Error: E806 Printer System Error
Probable cause: One or both print cartridges may be seated
incorrectly.
Solution: Be sure the print cartridges are seated correctly. If the
problem persists, replace the print cartridges. If E806 continues to be
displayed, call service.
Error: E810 Printer System Error
Probable cause: If you encounter this error and the system is still
working, then the print template is longer than 15 lines.
Solution: Enter Mode Setup Software and redefine the print template. If
you do not have Mode Setup Software, call service.
If you encounter this error and the system is not working, call service.
Error: E813 Printer System Error
Probable cause: This is a motor error; something has stopped the
progress of the motor in the Super12 Document Printer.
Solution: Perform the following steps:
1. Open the front door and clear any items that could block or interfere
with the swing arm.
2. Close the front door. The printer will move into the capped position
and any errors should clear.
If the error persists, call service.
A-61121 May 1999