Konica Minolta bizhub C451 User Manual page 401

Copy paper/original documents
4
Touch [Custom Size].
The Custom Size screen appears.
5
Type in the length (X) and width (Y) of the paper.
– Make sure that [X] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side X. (5-1/2 inch to 18 inch)
– Make sure that [Y] is selected, touch [↔] to switch between the in-
teger and the fraction, and then touch [–] and [+] to type in the
length of side Y. (3-9/16 inch to 12-1/4 inch)
– If a decimal value is displayed in the Custom Size screen, use the
keypad to type in the setting. For details on switching between dec-
imal and fraction values, refer to "System Settings" on page 11-20.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
To cancel changes to the settings, touch [Cancel].
C451
6
6-14