Table of Contents
Advertisement
Installation
To install the DFX 100 extender, follow these instructions:
1.
2.
3.
4.
5.
6.
7.
8.
Mount the DFX 100 Tx and DFX 100 Rx
Connect the provided power supply to the DFX 100 Tx
panel LED lights amber.
Connect the provided power supply to the DFX 100 Rx
panel LED lights amber.
Connect the transmitter and receiver
pages 5 and 6).
Connect the DVI-D display device to the DFX 100 Rx
on the display at this time.
Connect the DVI-D source device to the DFX 100 Tx
on the source at this time.
Power on the display device.
Power on the source device.
NOTE: The display device must be powered on before the source device to allow
correct DDC communication between the display and the source while the source
device is booting up.
When the DFX 100 Tx is receiving DVI-D input, the front panel lights green.
When the DFX 100 Rx is receiving an optical input, the front panel lights green.
in suitable locations (see page 8).
(see page 4). The front
(see page 5). The front
using a multimode fiber optic cable (see
(see page 5). Do not power
(see page 4). Do not power
DFX 100 • Installation
7
Advertisement
Table of Contents
