Lexmark W840 Finisher Service Manual page 31

989.00
Service finisher error
990.00
Service finisher error
990.01
Service finisher error
995.00
Service finisher NV
996.00
Service wrong finisher
999.00
Service finisher error
Close cover F
Close door G
Close surface H
Empty hole punch box
Insert hole punch box
Load staples
Stapler unit failure
Sensor (stapler
carriage HP) on failure
Sensor (stapler
carriage HP) off failure
Finisher NVM R/W
failure
Finisher type failure
Finisher engine/RIP
functional failure
Bridge unit cover is open
Finisher front door open
Eject cover is open
Punch waste box full
Punch waste box
missing
Staple cartridge empty
The off/on status of the sensor (stapler unit motor HP)
is not detected within the specified time after the
stapler unit motor (forward operation).
Or the sensor (stapler unit motor HP) is not turned on
within the specified timer after the stapler unit motor is
on (reverse operation).
Go to "989.00 Stapler unit failure" on page
The sensor (stapler carriage HP) is not turned on
within two seconds after the stapler starts moving
toward the staple position and also the sensor (stapler
carriage HP) is off.
Or the sensor (stapler carriage HP) is not turned on
after the stapler was moved to the staple position.
Or the sensor (stapler carriage HP) is turned off again
after the sensor (stapler carriage HP) is turned on and
the stapler stopped its moving.
Go to "990.00 Sensor (stapler carriage HP) on
failure" on page 2-78.
The sensor (stapler carriage HP) is not turned off
within 500 ms after stapler starts moving to the staple
position and sensor (stapler carriage HP) is off.
Or the sensor (stapler carriage HP) is not turned off
after the stapler was moved to the staple position.
Or the sensor (stapler carriage HP) is turned on again
after the sensor (stapler carriage HP) is turned off and
the stapler stopped its moving.
Go to "990.01 Sensor (stapler carriage HP) off
failure" on page 2-79.
A read/write error occurred on the NVM of the finisher
controller card assembly.
Go to "995.00 Finisher NVRAM R/W failure" on
page 2-80.
An incorrect type of finisher is connected.
Go to "996.00 Finisher type failure" on page
The engine reported a finisher failure that the RIP card
assembly did not recognize.
Go to "999.00 Finisher engine/RIP functional
failure" on page 2-81.
Finisher bridge unit cover is open.
Go to "999.00 Finisher engine/RIP functional
failure" on page 2-81.
The finisher front cover is open.
Go to "Finisher front door open" on page
The finisher eject cover is open.
Go to "Finisher eject cover open" on page
The punch waste box is filled.
Go to "Punch waste box full" on page
No punch waste box.
Go to "No punch waste box." on page
Go to "Staple cartridge empty" on page
4024-XXX
2-78.
2-80.
2-82.
2-83.
2-86.
2-85.
2-92.
2-9
Diagnostic information