Lexmark W840 Finisher Service Manual page 27

284.04
Paper jam
Check area H
284.05
Paper jam
Check areas H, G3
285.00
Paper jam
Check area H
286.00
Paper jam
Check area H
287.00
Check area F
287.01
Check area F
287.02
Paper jam
Check areas G1, G3
287.03
Paper jam
Check area G1
287.04
Paper jam
Check area G
Sensor (lower media
exit) off jam B
Sensor (lower media
exit) Static jam
Finisher eject set jam
Sensor (compiler media
in) Static jam
Sensor (upper media
exit) on jam A
Sensor (upper media
exit) off jam A
Sensor (upper media
exit) on jam B
Sensor (upper media
exit) on jam C
Sensor (upper media
exit) off jam B
Finisher sensor (lower media exit) not turned off within
the specified time after the finisher sensor (lower
media exit) on.
At this time, the sensor (finisher media entrance) is
turned on.
Go to "284.04 Sensor (lower media exit) off jam B."
on page 2-36.
Paper remains on the sensor (lower media exit).
Go to "284.05 Sensor (lower media exit) static jam"
on page 2-37.
Finisher sensor (compiler media in) is not turned on
within the specified time after the media eject motor is
turned on.
Go to "285.00 Finisher eject set jam" on page
Paper remains on the sensor (compiler media in).
Go to "286.00 Sensor (compiler media in) static
jam" on page 2-38.
Sensor (upper media exit) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "287.00 Sensor (upper media exit) on jam A"
on page 2-40.
Sensor (upper media exit) is not turned off within the
specified time after the sensor (upper media exit) is
turned on.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "287.01 Sensor (upper media exit) off jam A."
on page 2-41.
Sensor (upper media exit) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "287.02 Sensor (upper media exit) on jam B"
on page 2-42.
Sensor (upper media exit) is not turned on within the
specified time after the sensor (finisher media
entrance) is turned on.
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "287.03 Sensor (upper media exit) on jam C"
on page 2-44.
Sensor (upper media exit) is not turned off within the
specified time after the sensor (upper media exit) is
turned on.
At this time, the sensor (bridge unit media exit) is
turned off.
Go to "287.04 Sensor (upper media exit) off jam B."
on page 2-45.
4024-XXX
2-37.
2-5
Diagnostic information