Drive Motor (Exit) Assembly And Belt (Exit) Removal - Lexmark W840 Finisher Service Manual

Drive motor (exit) assembly and belt (exit) removal

1.
Remove the rear upper cover. See
2.
Loosen the two screws securing the belt tensioner bracket (A) to the finisher, and move it down as shown.
3.
Remove the belt (exit) (B) from the drive motor (exit) assembly (C).
4.
Disconnect the connector from the drive motor (exit) assembly.
"Rear upper cover removal" on page
A
A
(2)
(1)
B
Rear
4024-XXX
4-24.
C
Repair information
4-113