Lexmark W840 Finisher Service Manual page 30

4024-XXX
984.01
Service finisher error
985.00
Service finisher error
985.01
Service finisher error
986.00
Service finisher error
986.01
Service finisher error
987.00
Service finisher error
987.01
Service finisher error
988.00
Service finisher error
988.01
Service finisher error
2-8
Finisher Service Manual
Sensor (punch unit HP)
off failure
Sensor (punch carriage
shift HP) on failure
Sensor (punch carriage
shift HP) off failure
Sensor (media eject
clamp HP) on failure
Sensor (media eject
clamp HP) off failure
Sensor (media eject
shaft HP) on failure
Sensor (media eject
shaft HP) off failure
Sensor (punch unit side
reg1) on failure
Sensor (punch unit side
reg2) on failure
Sensor (punch unit side
reg1) off failure
Sensor (punch unit side
reg2) off failure
The sensor (punch unit HP) is not turned off even
when the specified time passed after the punch unit
motor is turned on.
Go to "984.01 Sensor (punch unit HP) off failure"
on page 2-67.
The sensor (punch carriage shift HP) is not turned on
even when the specified time passed after the punch
carriage shift motor assembly is turned on.
Or the sensor (punch carriage shift HP) is turned off
again after the sensor (punch carriage shift HP) is
turned on and the punch carriage shift motor assembly
stopped its rotation.
Go to "985.00 Sensor (punch carriage shift HP) on
failure" on page 2-68.
The sensor (punch carriage shift HP) is not turned off
even when the specified time passed after the punch
carriage shift motor assembly is turned on.
Or the sensor (punch carriage shift HP) is turned on
again after the sensor (punch carriage shift HP) is
turned off and the punch carriage shift motor assembly
stopped its rotation.
Go to "985.01 Sensor (punch carriage shift HP) off
failure" on page 2-69.
The sensor (eject clamp HP) is not turned on within
500 ms after the eject clamp up starts.
Go to "986.00 Sensor (media eject clamp HP) on
failure" on page 2-70.
The sensor (eject clamp HP) is not turned off within
200 ms after the eject clamp down starts.
Go to "986.01 Sensor (media eject clamp HP) off
failure" on page 2-71.
The sensor (media eject shaft HP) is not turned on
within 200 ms after the set clamp starts operating.
Go to "987.00 Sensor (media eject shaft HP) on
failure" on page 2-72.
The sensor (media eject shaft HP) is not turned off
within the specified time after the set clamp ends
operating.
Go to "987.01 Sensor (media eject shaft HP) off
failure" on page 2-74.
The sensor (punch unit side reg1) or sensor (punch
unit side reg2) did not detect the media correctly or is
defective.
Go to "988.00 Sensor (punch unit side reg) on
failure" on page 2-75.
The sensor (punch unit side reg1) or sensor (punch
unit side reg2) did not detect the media correctly or is
defective.
Go to "988.01 Sensor (punch unit side reg) off
failure" on page 2-76.