Error Code Messages - Lexmark W840 Finisher Service Manual

Error code messages

Error code or message
280.00
Paper jam
Check area A
280.01
Paper jam
Check area A
280.02
Check area F
281.00
Paper jam
Check area A
281.01
Paper jam
Check area F
281.02
Paper jam
Check area F
281.03
Paper jam
Check area F
282.00
Paper jam
Check area F
282.01
Paper jam
Check area F
Error contents
Sensor (bridge unit
media entrance) on jam
Sensor (bridge unit
media entrance) Static
jam A
Sensor (bridge unit
media entrance) Static
jam B
Sensor (bridge unit
media exit) on jam A
Sensor (bridge unit
media exit) on jam B
Sensor (Bridge unit
media exit) on jam C
Sensor (bridge unit
media exit) Static jam A
Sensor (finisher media
entrance) on jam
Sensor (finisher media
entrance) Static jam A
Description/action
Sensor (bridge unit media entrance) is not turned on
within the specified time after the sensor (fuser exit) in
the printer is turned on.
Go to "280.00 Sensor (bridge unit media entrance)
on Jam" on page 2-11.
Paper remains on the sensor (bridge unit media
entrance).
Go to "280.01 Sensor (bridge unit media entrance)
static jam A" on page 2-12.
Paper remains on the sensor (bridge unit media
entrance).
Go to "280.02 Sensor (bridge unit media entrance)
static jam B" on page 2-13.
Sensor (bridge unit media exit) is not turned on within
the specified time after the sensor (bridge unit media
entrance) turned on.
At this time, the sensor (fuser exit) in the printer is
turned on.
Go to "281.00 Sensor (bridge unit media exit) On
Jam A" on page 2-14.
Sensor (bridge unit media exit) is not turned on within
the specified time after the sensor (bridge unit media
entrance) turned on.
At this time, the sensor (bridge unit media entrance) is
turned on.
Go to "281.01 Sensor (bridge unit media exit) On
Jam B" on page 2-15.
Sensor (bridge unit media exit) is not turned on within
the specified time after the sensor (bridge unit media
entrance) is turned on.
Go to "281.02 Sensor (bridge unit media exit) On
Jam C" on page 2-17.
Paper remains on the sensor (bridge unit media exit).
Go to "281.03 Sensor (bridge unit media exit) static
jam A" on page 2-18.
Sensor (finisher media entrance) is not turned on with
the specified time after the sensor (bridge unit media
exit) is turned on.
Go to "282.00 Sensor (finisher media entrance) on
jam" on page 2-19.
Paper remains on the sensor (finisher media
entrance).
At this time, the sensor (bridge unit media exit) is
turned on.
Go to "282.01 Sensor (finisher media entrance)
static jam A" on page 2-21.
4024-XXX
2-3
Diagnostic information