Sensor (Diverter Gate) Static Jam (To Top Bin) C - Lexmark W840 Finisher Service Manual

Step Check
4 Is the drive motor (entrance/paddle) connected
properly?
5 Perform a test print.
Does the error still occur?

288.03 Sensor (diverter gate) static jam (to top bin) C

Step Check
1 Check the sensor (diverter gate) for correct operation.
Perform the Diverter gate test.
1. Enter Diagnostics mode.
2. Select FINISHER TESTS.
3. Select Sensor Tests.
4. Select Media Path2.
5. Select Diverter gate.
Does the display on the operator panel change every
time a piece of white media is placed over the sensing
area of the sensor (diverter gate)?
2 Check the sensor (diverter gate) connection.
Is the above senor connected properly?
3 Check the drive motor (entrance/paddle) by opening
the finisher front door assembly and then closing it.
Does the motor (entrance/paddle) rotate normally?
4 Is the drive motor (entrance/paddle) connected
properly?
Yes No
Replace the drive Replace the
motor (entrance/ connection.
paddle). See
"Drive motor
(entrance/
paddle) and belt
(entrance/
paddle)
removal" on
page 4-100.
Replace the Problem solved.
finisher controller
card assembly.
See "Finisher
controller card
assembly
removal" on
page 4-118.
Yes No
Go to step 3. Go to step 2.
Replace the Replace the
sensor (diverter connection.
gate). See
"Sensor
(diverter gate)
removal" on
page 4-110.
Go to step 5. Go to step 4.
Replace the drive Replace the
motor (entrance/ connection.
paddle). See
"Drive motor
(entrance/
paddle) and belt
(entrance/
paddle)
removal" on
page 4-100.
Diagnostic information
4024-XXX
2-53