Bridge Unit Rear Cover Removal - Lexmark W840 Finisher Service Manual

4024-XXX
8.
Remove the two screws securing the finisher docking bracket (D) to the printer.
9.
Remove the finisher docking bracket (D).
Replacement note: When docking the finisher to the printer, make sure the boss on the finisher docking
bracket (D) is inserted into the hole on the finisher docking latch assembly (C). The finisher should be firmly
locked into position.

Bridge unit rear cover removal

1.
Remove the bridge unit assembly. See
2.
Remove the two screws securing the bridge unit rear cover (A) to the bridge unit assembly (B).
3.
Remove the bridge unit rear cover (A).
4-6
Finisher Service Manual
Boss
D
"Bridge unit assembly removal" on page
B
C
4-2.
A