Manual Internet Setup - D-Link DIR-505 User Manual

Section 3 - Router Mode
If you clicked Manual.Internet.Connection.Setup on the Internet.Settings.page, you will see this screen. Here, you can
configure the Internet connection for your DIR-505. After making your changes, click the Save.Settings button.
Operation This should be set to Router mode. If you want to use Access
Mode:
Point mode, select Access Point mode and click the Save
Settings button to switch to the Access Point configuration
interface. For more information, refer to "Access Point Mode"
on page 74.
Select the connection mode to use: Dynamic.IP.(DHCP),
Host Name:
PPPoE, PPTP, or L2TP. The remaining settings will change
depending on which connection mode you use.
Note: Most cable modem connections use DHCP, and
most DSL connections use PPPoE. If you are not sure which
connection mode to use, contact your Internet service
provider.
D-Link DIR-505 User Manual

Manual Internet Setup

30