Manual Internet Setup; Dynamic (Cable) - D-Link DIR-505 User Manual

Section 3 - Configuration
Operation Mode: Select Router or Access point from the drop-down menu.
Select Dynamic.IP.(DHCP) to obtain IP Address information
My Internet
automatically from your ISP. Select this option if your ISP does
Connection:
not give you any IP numbers to use. This option is commonly
used for cable modem services.
Host Name:
The Host Name is optional but may be required by some ISPs.
Leave blank if you are not sure.
Use Unicasting:
Check the box if you are having problems obtaining an IP
address from your ISP.
Primary/Secondary
Enter the Primary and secondary DNS server IP addresses
DNS Server:
assigned by your ISP. These addresses are usually obtained
automatically from your ISP. Leave at 0.0.0.0 if you did not
specifically receive these from your ISP.
MTU: Maximum Transmission Unit - you may need to change the
MTU for optimal performance with your specific ISP. 1500 is
the default MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical
interface MAC address on the Broadband Router. It is not
recommended that you change the default MAC address
unless required by your ISP. You can use the Copy.Your.PC's.
MAC. Address button to replace the Internet port's MAC
address with the MAC address of your Ethernet card.
D-Link DIR-505 User Manual

Manual Internet Setup

Dynamic (Cable)

36