Lan Setup - D-Link DIR-505 User Manual

Section 4 - Access Point Mode
Here, you can configure the network settings of the DIR-505. After making your changes, click the Save.Settings button.
Operation This should be set to Access. Point mode. If you want to
Mode: use Router mode, select Router mode and click the Save.
Settings. button to switch to the Router configuration
interface. For more information, refer to "Router Mode" on
page 24.
Device Name:
Enter a name for the DIR-505.
My LAN Select whether you want to connect your DIR-505 to your
Connection network through Dynamic.IP.(DHCP) or Static.IP.
is:
If you selected Static. IP, fill in the IP. Address, Subnet.
Mask, Gateway. Address, and Primary and Secondary.
DNS.Server addresses. If you are not sure what settings to
use, please contact your network administrator or Internet
service provider.
D-Link DIR-505 User Manual

LAN Setup

80