D-Link DIR-505 User Manual page 37

Section 3 - Router Mode
If you selected PPPoE, you will see the following settings. Your ISP will provide you with a username and password. This option
is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software is no longer
needed and will not work through a router.
Address Select Static.IP if your ISP assigned you an IP address, subnet
Mode: mask, gateway, and DNS server address. In most cases, select
Dynamic.IP.
IP Address:
Enter the IP address (for static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password
in the next box.
Service Enter the ISP service name (optional).
Name:
Reconnect Select either Always-on, On-Demand, or Manual.
Mode:
Maximum Enter a maximum idle time during which the Internet
Idle Time: connection is maintained during inactivity. To disable this
feature, set the Reconnect.Mode to Always.on.
Primary/ Enter the primary and secondary DNS server addresses
Secondary (Static PPPoE only).
DNS Server:
MTU: If you experience connection issues, you may need to
change the MTU setting for optimal performance with your
specific ISP. 1492 is the default MTU.
D-Link DIR-505 User Manual 32