Lan Setup - D-Link DIR-505 User Manual

Section 5 - Repeater Mode
This section will allow you to change the local network settings of the DIR-505. After making your changes, click the Save.
Settings button.
Device Name: Enter the Device Name of the DIR-505. It is recommended
that you change the Device Name if there is more than one
D-Link device in your subnet.
LAN Use the drop-down menu to select the LAN Connection
Connection Type to use.
Type:
Select Dynamic IP (DHCP) to automatically obtain an IP
address on the LAN/private network.
Select Static IP Address if all the Internet port's IP information
is provided to you by your ISP.
If you choose DHCP as your connection type:
IP Address:
Enter the IP address of the access point. The default IP
address is 192.168.0.1. If you change the IP address, once
you click Apply, you will need to enter the new IP address
in your browser to get back into the configuration utility.
Subnet Mask: Enter the Subnet Mask assigned by your ISP.
Gateway Enter the Gateway assigned by your ISP.
Address:
D-Link DIR-505 User Manual

LAN Setup

103