AT&T 6300 Service Manual page 111

INSTALLATIONS
19. Remove the wrist strap (if wrist strap was used).
20. Secure the Memory Expansion Board by fastening the
retaining bracket to the rear panel.
21. Replace the upper System Module cover and tighten the two
cover screws.
22. Connect the cables that were disconnected (Keyboard,
Display, Printer, etc.) back to the rear panel.
23. Connect the ac power cable to the rear panel.
24. Verify that the RAM passes the Resident Diagnostics and
then run the Customer Test Diagnostics in the Automatic
Mode. (Refer to Chapter 4.)
3..35