3C589C Pc Card Diagnostic Program; Testing The 3C589C Pc Card - 3Com ETHERLINK III LAN PC CARD User Manual

6-2 C
HAPTER
Refer to the manual that accompanied the memory manager
software for additional instructions and information on how
to exclude memory.
4 Save the CONFIG.SYS file and exit the text editor.
5 Reboot the PC.
This completes the procedure for avoiding conflicts with a
memory manager.

3C589C PC Card Diagnostic Program

Run the diagnostic program for your installed 3C589C
PC Card when you need to do the following:
Test for setup/configuration and cabling
Test for PC Card problems
View PC Card statistics
If you have already installed the network driver, you need to
reboot and press [F5] or use a DOS diskette before you run the
diagnostic program. Use a DOS diskette if you are running
DOS 5.0 or earlier.

Testing the 3C589C PC Card

Follow these steps to run the 3C589C PC Card diagnostic
program to test the 3C589C PC Card itself and the setup:
1 Place the EtherDisk diskette in a diskette drive on your PC
and make that drive the active drive. For example, type:
A: [Enter]
2 Type at the prompt:
Install [Enter]
The main screen appears, as shown in Figure 6-1.
6: T
ROUBLESHOOTING