Table of Contents
Advertisement
SERVICE TABLES AND PROCEDURES
BIT SWITCHES
4.2. BIT SWITCHES
WARNING
Do not adjust a bit switch that is described as "Not used", as this may
cause the machine to malfunction or to operate in a manner that is not
accepted by local regulations. Such bits are for use only in other
areas, such as Japan.
Note: Default settings for bit switches are not listed in this manual. Refer to
the System Parameter List printed by the machine.
4.2.1. System Switches
System Switch 00
No
FUNCTION
RAM Reset
Bit 1
Bit 0 Reset Level
0
0
0
1
1
0
1
1
0
1
Reset Level 3: Erases all image data files stored in
the SAF memory and communciation files (e.g. polling
rx file). This setting is recommended for use when it is
No reset
necessary to clear the SAF.
Reset Level 2
Always use this reset level after the software has been
Reset Level 3
updated by a remote diagnostics system. (This reset is
Not used
not necessary after local software update.)
Reset Level 2: In addition to those items erased by
Reset Level 3, the following items are erased: own
telephone number, bit switches, RTI/TTI/CSI, report
data, programmed telephone numbers (Quick/Speed/
Groups, service station, etc.), NCU parameters,
personal codes.
After erasing, the machine changes these two bits
back to 0 automatically.
No reset: Normal operation
Cross reference
RAM Reset Level 1 (Factory reset):
Change the data in RAM address 480000(H) to FF(H),
then turn the machine off and on. In addition to those
items erased by Reset Level 2, the clock and
scan/print registration settings are erased.
Note
After a RAM reset level 1 or 2, initial toner supply will
be done automatically for 90 s.
COMMENTS
4-24
December 21st, 1995
Advertisement
Table of Contents
