Description Of Menu Items; Main Menu - Roland EGX-350 User Manual

5-5 Description of Menu Items

Main Menu

 P. 84, "Main Menu" (Menu List)
80
Chapter 5 Feature reference
This is the main screen. This screen is displayed at startup and when executing
cutting.
When [AUTO Z CONTROL] is set to "ON, " the Z-axis coordinate display changes to
"AUTO. " When [REVOLUTION] is set to "OFF, " the spindle-speed display changes to
"S OFF. "
 P. 90, "Others Menu"
This makes the setting for the moving speed of the cutter during engraving, or
the Cutter Feed Rate.
The rates for the X-and Y-axis directions and the Z-axis direction can be respectively
set. For the 3-axis simultaneous feeding operation, the setting of the "ZSPEED" will
be applied. If there are any settings made with the computer, such settings with
the computer will be preferentially applied.
 Default setting
X- and Y-axis directions: 2mm/sec
Z-axis direction: 2mm/sec
 Setting range
X- and Y-axis directions: 0.1 to 60 mm/sec (From 0.1 to 0.9mm/sec, the setting can
be made with 0.1 increment in between. But the number is displayed without 0
before the decimal point. From 1 to 60mm/sec, the least input increment is 1.)
Z-axis direction: 0.1 to 30mm/sec (from 0.1 to 0.9mm/sec, the setting can be made
with 0.1 increment in between. But the number is displayed without 0 before the
decimal point. From 1 to 30mm/sec, the least input increment is 1.)
The spindle head moves to the selected location.
 P. 45, "Moving to a Specific Position Automatically"
These call up the corresponding submenus.
 P. 89, "I/O Menu," p. 90, "Others Menu," p. 91, "Adjustment Menu"
Note: When [AUTO Z CONTROL] is set to "ON, "
"" is displayed to the right of "Z" during Z-axis
origin detection.