Roland EGX-350 User Manual page 67


If cutter insertion is difficult
If the cutter catches on the solid collet and is difficult
to insert, loosening the cutter holder makes inser-
tion easier. Note that inserting it with undue force
may result in damage to the workpiece. After insert-
ing the cutter, tighten the cutter holder again.

Cutter holder
Hexagonal
screwdriver
Cutter
Cutter holder
Workpiece
Loosen the cutter holder.
Mounting screw
4-5 Cutter Installation Method 2 (No Nose Unit)
Insert the cutter into the cutter holder
and bring the tip of the cutter into
contact with the surface of the work-
piece.
Placing a thin sheet of paper on the workpiece
can prevent damage to the workpiece when the
cutter touches it. However, take the thickness of
the paper into account when you set the Z-axis
origin.
When using a diameter-4.36 mm solid
collet
Be careful to orient the cutter correctly.
Cutter
Solid collet
Tab
OK
Secure the cutter in place.
Tighten the mounting screw for the cutter
holder.
Chapter 4 Engraving
Tab
Not OK
65