Roland EGX-350 User Manual page 72

4-6 Cutter Installation Method 3 (Diamond Scraper)

This completes the installation of the cutter. Go on to page 75, "Setting the XY Origin Point
(Home Position)."
If diamond scraper insertion is difficult
If the diamond scraper catches on the solid collet and is difficult to
insert, loosening the cutter holder makes insertion easier. Note that
inserting it with undue force may result in damage to the work-
piece. After inserting the diamond scraper, tighten the cutter holder
again.
Storage methods for diameter-3.175 mm cutters
When you want to perform repeated use while keeping the amount of extension of the diamond scraper tip
constant, then once you've decided on the amount of extension, we recommend removing the cutter holder and
diamond scraper from the spindle unit without separating them from one another. Storing the assembly without
changing the position of the cutter holder eliminates the need to determine the amount of cutter extension each
time with every use.
Remove the entire cutter-holder assembly
from the spindle unit.
70
Chapter 4 Engraving
Cutter holder
Mounting screw
Hexagonal
screwdriver
Diamond Scraper
Secure the diamond scraper in
place.
Tighten the mounting screw for the cutter holder.
For the amount of extension of the tip of the
diamond scraper, a value of about 10 millimeters
may work well.
Loosen the cutter holder.
Store without changing the position
of the cutter holder.