Performing Engraving - Roland EGX-350 User Manual

4-9 Performing Engraving

Performing Engraving

Make sure the following tasks have all been completed, then sent the engraving data from the computer and perform
engraving.
 Mounting a Workpiece
 P. 54, "Mounting a Workpiece"
 Cutter Installation
 P. 56 through 74, "Cutter Installation Method 1" through "Cutter Installation Method 4"
 Setting the XY Origin Point
 P. 75, "Setting the XY Origin Point (Home Position)"
For information about creating engraving data, refer to the documentation for the program you're using to create the
data.
76
Chapter 4 Engraving