Cutter Installation Method 1 (With Nose Unit); Installing A Character Cutter (With Nose Unit) - Roland EGX-350 User Manual

4-4 Cutter Installation Method 1 (With Nose Unit)

Installing a Character Cutter (With Nose Unit)

WARNING
WARNING
CAUTION
Type of cutter used
Nose-unit usage
Suitable workpiece types
Automatic Z-axis control
Spindle rotation
Lock-lever position
This performs engraving using the nose unit. When the tip of the nose unit touches the surface of the workpiece, the location
is automatically detected as the Z origin point. This makes it possible to perform engraving at a uniform depth on a work-
piece of uneven surface height. This also eliminates the need to set the Z-axis origin point each time when you're engraving
a number of different workpieces.
1.
Install the cutter holder, solid collet, and nose unit.

56
Chapter 4 Engraving
Never inadvertently touch the computer or handy panel while performing this
task.
Unintended operation of the machine may result in injury.
Securely fasten the cutting tool and in place. After securing in place, make sure
no wrenches or other articles have inadvertently been left behind.
Otherwise such articles may be thrown from the machine with force, posing a risk
of injury
Caution: cutting tool.
The cutting tool is sharp. To avoid injury, exercise caution.
Character cutter or flat cutter
Used
Acrylic and other plastic-resin panels
Note: Aluminum, brass, and other easily scratched workpieces are not suitable.
On
On
or
Wrench
Cutter holder
Spindle unit
Install the cutter holder
While holding the spindle unit immobile with a
wrench, tighten the cutter holder.
The cutter holder is reverse-threaded (that is, you
turn it counterclockwise to tighten it). Be careful
to turn it in the correct direction.
Hexagonal
screwdriver
Loose
Cutter holder