Table of Contents
Advertisement
3.
Make the settings for spindle speed and Z-axis control.
4.
Set the Z-axis origin point.
Use
,
piece.
Next, perform a small amount of cutting into the workpiece. Move to a location where cutting will not cause any
problems.
P. 44, "Manual Movement"
Close the front cover, then press and hold
The spindle rotates.
P. 47, "Starting and Stopping Spindle Rotation"
Workpiece
Press
.
The spindle stops.
Press
several times to display the screen shown at left.
Use
and
Press
Use
to select "ON."
Press
Press
.
Use
to select "OFF."
Press
The message shown at left is displayed for three seconds, and then the original
screen returns.
Press
several times to return to the main screen.
,
and
to move the end mill to a location above the work-
End mill
4-7 Cutter Installation Method 4 (End mill)
to select [OTHERS].
.
to confirm.
to confirm.
for at least one second.
Press
location where the workpiece is cut by
a slight amount.
Chapter 4 Engraving
to lower the end mill to a
73
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
