Manual Movement - Roland EGX-350 User Manual

3-4 Moving the Cutter

Manual Movement

When the screen on the handy panel displays any one of the messages shown in the figure below, you can move the cutter
manually using the movement buttons.
 P. 84, "Menu List"
Movement along all axes
(X, Y, and Z)
Movement along only the X
and Y axes
Movement along only the Z axis
("XXX" is "DOWN," "SURFACE,"
or "UP. " )
 Each single press of
 Holding down
 Holding down
continuous movement.
Important!
This operation is not possible in the following cases.
 When engraving is in progress
 When operation is paused
44
Chapter 3 Basic Operation
Handy panel
Movement buttons
, , ,
, , , ,
while pressing and holding
, or performs movement by 0.01 millimeter.
or performs slow continuous movement.
, , , , or performs rapid