Roland EGX-350 User Manual page 59


Wrench
Spindle unit
Wrench

Nose unit
Loose
4-4 Cutter Installation Method 1 (With Nose Unit)
Install the solid collet.
Insert the solid collet into the spindle unit from
below, then, while holding the spindle unit im-
mobile with a wrench, tighten loosely.
Use an appropriate solid collet for the cutter's
diameter.
Solid collet
Using two wrenches, tighten the solid collet fully.
The appropriate tightening torque is 3.2 N-m
(32kgf-cm) .
Wrench
Install the nose unit.
Tighten until no further movement is possible,
then loosen two turns.
 P. 61, "Important Notes When Using the Nose Unit"
Tighten
Loosely tighten the solid collet.
Fully tighten the solid collet.
Chapter 4 Engraving
57