Table of Contents
Advertisement
4-5 Cutter Installation Method 2 (No Nose Unit)
3.
Make the settings for spindle speed and Z-axis control.
4.
Install the cutter and set the Z-axis origin point.
Workpiece
64
Chapter 4 Engraving
Press
several times to display the screen shown at left.
Use
and
to select [OTHERS].
Press
.
Use
to select "ON."
Press
to confirm.
Press
.
Use
to select "OFF."
Press
to confirm.
The message shown at left is displayed for three seconds, and then the original
screen returns.
Press
several times to return to the main screen.
Solid collet
Use
,
,
to move the spindle head to the area
above the workpiece, then press
to lower the spindle head.
Stop at a position where the tip of the solid collet
is approximately 10 millimeters from the surface
of the workpiece.
P. 44, "Manual Movement"
,
and
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
