Storage Screen; Figure 27 - Storage Screen - ADT A-SDR400LTE-80 User Manual

User's Manual
The Status field displays the fault conditions. When it is Good, there was recording or an alarm
occurred during the designated time. When it is Bad, there was no recording or no alarm occurred
during the designated time.
Highlight the box beside the On Record Problem: Alarm Out and press the button. A drop
menu displays the available alarm outputs for the recording problem. Highlight the desired alarm
output from no alarm output, external alarm out terminal, internal buzzer or notify, and press the
button.

Storage Screen

Highlight Storage in the Main menu and press the button. The Storage setup screen appears.
Figure 27 — Storage screen.
The Type field displays the type and capacity of storage devices.
The Status field displays the device status or fault conditions. (Good, Disk Bad, S.M.A.R.T.
Alert, High Temperature, or Not installed)
NOTE: If the DVR senses S.M.A.R.T. Alert or High Temperature, the S.M.A.R.T. Monitoring
Information screen will appear. Once the S.M.A.R.T. Monitoring Information screen displays,
replacing the hard disk drive is recommended, usually within 24 hours.
NOTE: The S.M.A.R.T. Monitoring Information screen appears only in the monitoring mode.
°C
The field displays the temperature of the storage device.
The Usage field displays the device usage.
The DVR can be set to react to storage problems by activating an internal buzzer or external alarms,
display the warning message and/or notifying a PC running RAS (Remote Administration System).
Highlight the box beside Storage Problem Action: Alarm Out / Notify and press the button to
select from Beep, the alarm output terminal that you want to associate with the storage problem
event, and/or Notify.
20