Quick Setup Screen; Figure 17 - Quick Setup Screen - ADT A-SDR400LTE-80 User Manual

User's Manual

Quick Setup Screen

Figure 17 — Quick Setup screen.
The Quick Setup screen allows you to set up the most commonly used features of your DVR. Use
the arrow buttons to move through the options. Pressing the button lets you make your
selections.
Highlight the box beside Quick Setup and press the button to toggle between On and Off. If
you select Off, you will use the Normal Setup screen to change the DVR's settings.
Highlight the first box beside Recording Speed/Quality, and select recording speeds from as few
as 0.5 ips to as fast as 15 ips (12.5 ips for PAL).
NOTE: The DVR has a maximum recording speed of 15 ips per camera; however, the
recording speed may not be achieved when averaged over all cameras.
Highlight the second box beside Recording Speed/Quality, and select from High and Standard.
Highlight the box beside Audio Recording and select either On or Off.
NOTE: It is the user's responsibility to determine if local laws and regulations permit
recording audio.
Highlight the box beside Sequence Dwell Time and select from 3 to 60 seconds for the camera
sequence dwell time.
Selecting System Information enters a screen where you can set up system information.
Selecting Storage... enters a screen where you can check the storage status.
Selecting Camera... enters a screen where you can set up camera information.
Selecting Network Setup... enters a screen where you can set up network information.
12