Setting The Sp; Changing The Sp - Omron E5GN User Manual

CHAPTER 3 BASIC OPERATION

3.6 Setting the SP

Operation level
JChanging the SP
Operation Procedure
Operation level
3–10
The operation level" is displayed when the E5GN is turned ON. The left
display (No.1 display) displays the process value, and the right display
(No.2 display) displays the set point.
• The set point cannot be changed when the operation/adjustment
protection" parameter is set to 3". For details, see 4.8 Using the Key
Protect Levels."
• To change the set point, press the
parameter (operation level), and set the desired set value. The new set
point is selected two seconds after you have specified the new value.
In this example, let's change the set point from 0_C" to 200_C".
(1) Normally, the PV/SP" parameter is displayed. The set point is 0_C".
(2) Press the or
or
keys until the set point changes to 200_C".
keys in the PV/SP"